[May 28, 2026] Updates Up to 365 days On Valid 300-415 Braindumps
Best Quality300-415 Exam Questions Cisco Test To Gain Brilliante Result
To prepare for the exam, Cisco offers a range of training options, including classroom-based courses, online courses, and self-paced e-learning modules. There are also numerous study guides, practice exams, and other resources available online. It is recommended that candidates have practical experience with SD-WAN solutions before taking the exam.
NEW QUESTION # 17
The engineer is configuring the vSmart controller to transmit the initial set of non-best routes to the vEdge routers. Which configuration command is required under the Overlay Management Protocol to satisfy the requirements?
- A. send-path-limit 10
- B. send backup paths
- C. controller-send-path-limit 10
- D. send-backup-paths
Answer: D
Explanation:
The send-backup-paths command under OMP configuration on the vSmart controller enables it to advertise non-best (backup) routes to vEdge routers. This allows the vEdge to have standby paths ready for failover or application-aware routing decisions. It is essential for ensuring resiliency and optimizing path selection.
NEW QUESTION # 18
Refer to the exhibit.
The tunnel interface configuration on both WAN Edge routers is:
Which configuration for WAN Edge routers will connect to the Internet?
- A. Option A
- B. Option C
- C. Option D
- D. Option B
Answer: D
Explanation:
https://sdwan-docs.cisco.com/Product_Documentation/Software_Features/SD-WAN_Release_16.3
/02System_and_Interfaces/07Network_Interface_Configuration_Examples
NEW QUESTION # 19
Drag and drop the route verification output from show omp tlocs from the left onto the correct explanations on the right.
Answer:
Explanation:
* TLOC IP
* COLOR
* ENCAPSULATION
* shows if the route was chosen to enter the routing table or not
NEW QUESTION # 20
Drag and drop the vManage policy configuration procedures from the left onto the correct definitions on the right.
Answer:
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/policies/vedge/policies-book/data-policies.html
NEW QUESTION # 21
What is an advantage of using auto mode versus static mode of power allocation when an access point is connected o a PoE switch port?
- A. All four pairs of the cable are used
- B. Power policing is enabled at the same time
- C. It detects the device is a powered device
- D. The default level is used for the access point
Answer: D
Explanation:
https://www.cisco.com/en/US/docs/switches/lan/catalyst3850/software/release/3.2_0_se/multiboo k/configuration_guide/b_consolidated_config_guide_3850_chapter_011010.html
NEW QUESTION # 22
The Cisco SD-WAN engineer is configuring service chaining for a next-generation firewall located at the headquarters. Which configuration creates the service?
- A.
- B.
- C.
- D.
Answer: D
NEW QUESTION # 23
Refer to the exhibit. A small company was acquired by a large organization. As a result, the new organization decided to update information on their Enterprise RootCA and generated a new certificate using openssl.
Which configuration updates the new certificate and issues an alert in vManage Monitor | Events Dashboard?
- A.
- B.
- C.
- D.
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/solutions/CVD/SDWAN/cisco-sdwan-controller-cert- deploy-guide.html
NEW QUESTION # 24
Refer to the exhibit.
Refer to the exhibit. Which configuration value is used to change the administrative distance of iBGP routes to 20?
- A. Configure External routes distance 20
- B. Configure internal Routes Distance to 20
- C. Configure Local Distance to 20
- D. Configure Propagate AS Path to off
Answer: C
NEW QUESTION # 25
In Cisco SD-WAN, what protocol is used for control connections between SD-WAN devices?
- A. OSPF
- B. DTLS
- C. OMP
- D. BGP
Answer: C
NEW QUESTION # 26
Which policy configuration must be used to classify traffic as it enters the branch WAN Edge router to be put into the desired output queue?
- A.
- B.
- C.
- D.
Answer: D
NEW QUESTION # 27 
Refer to the exhibit. The Cisco SD-VYAN is deployed using the default topology. The engineer v/ants to configure a service insertion policy such that all data traffic between Rome to Paris is forwarded through the NGFW located in London. Which configuration fulfills this requirement, assuming that the Sen/ice VPN ID is
1?
- A.
- B.
- C.
- D.
Answer: B
NEW QUESTION # 28
Refer to the exhibit.
Which two configurations are needed to get the WAN Edges registered with the controllers when certificates are used? (Choose two)
- A. Generate a CSR manually within vManage server
- B. Install the certificate received from the CA server manually on the vManage
- C. Install the certificate received from the CA server manually on the WAN Edge
- D. Request a certificate manually from the Enterprise CA server
- E. Generate a CSR manually on the WAN Edge
Answer: A,B
Explanation:
https://www.cisco.com/c/dam/en/us/td/docs/solutions/CVD/SDWAN/cisco-sd-wan-certificates-deploy-2020aug.pdf
NEW QUESTION # 29
How must the application-aware enterprise firewall policies be applied within the same WAN Edge router?
- A. within and between zones
- B. within zone pair
- C. between two VRFs
- D. between two VPN tunnels
Answer: B
NEW QUESTION # 30
Drag and drop the policies from the left onto the correct policy types on the right.
Answer:
Explanation:
NEW QUESTION # 31
Refer to the exhibit.
Refer to the exhibit An engineer is configuring a QoS policy to shape traffic for VLAN 100 on a subinterface Which policy configuration accomplishes the task?
- A.
- B.
- C.
- D.
Answer: A
NEW QUESTION # 32
Drag and drop the definitions from the left to the configuration on the right.
Answer:
Explanation:
Explanation:
NEW QUESTION # 33
Drag and drop the Cisco SD-WAN components from the left onto their functions on the right.
Answer:
Explanation:
NEW QUESTION # 34
Drag and drop the attributes from the left that make each transport location unique onto the right. Not all options are used.
Answer:
Explanation:
NEW QUESTION # 35
Refer to the exhibit. vEdge101 has six possible routes to connect to spokes. However, only four routes are currently in use. Which CLI configuration ensures that all six routes are used?
- A. vsmart#
omp
no shutdown
send-path-limit 16
send-backup-paths
graceful-restart - B. vsmart #
omp
no shutdown
send-backup-paths
graceful-restart - C. vEdge101#
omp
no shutdown
send-backup-paths
send-path-limit 16
graceful-restart - D. vEdge101#
omp
no shutdown
send-path-limit 16
graceful-restart
Answer: A
Explanation:
The vSmart controller controls which OMP paths are advertised to vEdge devices.
To allow all 6 transport paths (colors) to be used simultaneously, you must:
- Increase the send-path-limit (default is 4),
- Enable send-backup-paths to allow use of additional TLOCs,
- Apply these changes on the vSmart, which is responsible for path advertisement to vEdges.
NEW QUESTION # 36
Drag and drop the route verification output from show omp tlocs from the left onto the correct explanations on the right.
Answer:
Explanation:
NEW QUESTION # 37
Refer to the exhibit.
What does the BFD value of 8 represent?
- A. poll-interval of BFD session.
- B. dead timer of BFD session
- C. hello timer of BFD session
- D. number of BFD sessions
Answer: D
NEW QUESTION # 38
Drag and drop the actions from the left into the correct sequence on the right to create a data policy to direct traffic to the Internet exit.
Answer:
Explanation:
Explanation:
Step 1 - Enable NAT Functionality
Step 2 - Create centralized data policy
Step 3 - Identify VPN and match criteria
Step 4 - Apply data policy
NEW QUESTION # 39
......
Focus on 300-415 All-in-One Exam Guide For Quick Preparation: https://validdumps.free4torrent.com/300-415-valid-dumps-torrent.html